Geckollect-A+ devices can be configured over USB via a Micro USB-B cable and compatible browser.
Device port: -
Use this field to remotely configure the Geckollect-A+ device on the connected network.
Make sure to push the CONF button on the device, and wait for the configuration mode lights.
Then find it's IP on your network, and input it here.
Device IP: . . .
Loading system information. This might take seconds...
System status loaded.
Cannot load system status. (DO NOT CLOSE THIS PAGE! Retrying...)
WiFi interface status loaded.
Cannot load wifi interface status.
GSM interface status loaded.
Cannot load GSM interface status.
Pair list loaded.
Cannot load pair list.
Available radio list loaded.
Cannot load available radio list.
Available WiFi AP scan complete.
Cannot list available WiFi AP scan.
| DC ID | - |
| Status | on |
| Internet | - |
| System clock | - |
| DC adaptor | - |
| System voltage | - |
| Battery voltage | - |
| Version | SW rev. 3, UI v3.1 |
| State | - |
| Network | - |
| IP address | - |
| Signal strength | - |
| Gateway |
| Radios | - |
| Modem | - |
| Operator | - |
| Channel | - |
| Signal strength | - |
| Connection | - |
| APN | |
| PIN |
| name | RSSI | encyption | |
| WiFi scan returned no networks. | |||
| SSID (name) | |
| Passphrase |
| RadioID | |
| No paired radios. | |
| RadioID | RSSI | |
| No available radios. | ||
Pair without power
| RadioID |